
Pier and Beam Foundation Repair in Carrollton, TX
Carrollton Superior Foundation Repair offers professional pier and beam foundation repair in Carrollton, TX with 19 years of experience and crews who spend a good part of every week in crawl spaces. We replace rotted cedar stumps and loose block piers with concrete pier pads, re-shim girders with steel shims, and sister damaged sill plates and floor joists. Most re-shim and re-level jobs take 1 to 2 days.
A pier and beam house moves differently than a slab. The floor sits on beams, the beams sit on piers, and the piers sit on clay, so the problem is usually one of those three giving way. A full re-shim and re-level runs $1,800 to $4,800, new interior pier pads run $375 to $600 each, and a perimeter beam that dropped gets pressed concrete pilings the same way a slab would.
Get a FREE Estimate
Or call (469) 896-0932
Pier and Beam Foundation Repair Options
Most pier and beam jobs are some mix of these five. The crawl space inspection tells us which.

Pier and Beam Re-Shimming
Shims crush, slip and rot over the years, and the floor above them starts to roll. We jack each girder off its pier, pull the old shims and set steel shims to the height the elevation survey calls for. On a sound set of piers, that's often the whole repair.

Pier and Beam Pier Replacement
Older houses often still sit on cedar stumps or dry-stacked block. When a stump has gone soft at the ground line, re-shimming it is putting new tires on a rusted-out axle. We dig out the old pier and set a concrete pier pad at $375 to $600 each.

Pier and Beam Sill Plate and Girder Repair
Termites and years of moisture eat the sill plate where the house meets the perimeter beam, and girders sag where they span too far. We sister damaged sections with pressure-treated lumber at $40 to $75 per linear foot and add a pier where a girder needs mid-span support.

Pier and Beam Perimeter Beam Piering
The concrete perimeter beam around a pier and beam house sits in the same clay as a slab and drops the same way. We press concrete pilings under it at 6 to 8 feet on center, then bring the interior piers up to match so the floor comes up as one piece.

Pier and Beam Crawl Space Moisture Control
Standing water softens pier footings and rots framing from below. We fix grading and drainage around the house first, then lay a 20-mil reinforced vapor barrier if the crawl space stays damp. Full encapsulation is its own job, but we check for the need on every pier and beam inspection.
Before and After
Signs Your Pier and Beam House Needs Repair
Pier and beam floors talk more than slabs do. You'll feel a soft spot or a dip walking across a room, see the floor slope toward an outside wall, or notice a bounce near the middle of the house where a girder has sagged.
Doors drift open or shut on their own. Interior walls crack at the corners of doorways. Dishes rattle when somebody walks past the cabinet. If you can reach the crawl space hatch, look for wet soil, shims that have slid sideways or a pier leaning off plumb.
None of that means the house is unsafe. It means something under it moved, and most of the time it's fixable in 1 to 2 days.
What We Find Under Older Pier and Beam Houses
Most Carrollton homes were built on slabs during the 1970s and 1980s. Pier and beam is common in the older homes built before that era, plus garage conversions and additions. Those older supports have had decades to wear out.
Cedar Stumps and Stacked Block
Cedar was the pier of choice for a long time. It holds up for decades, then goes soft right at the ground line. Stacked block without a footing walks sideways in clay. On one 1950s house we replaced 23 rotted cedar stumps, along with the brick and shingle shims a previous owner had jammed in to keep the floors flat.
Sill Plates and Termite Damage
The sill plate is where termites and old roof leaks tend to meet. We probe it end to end during the inspection, mark the soft sections on the floor plan and price the sistering by the linear foot, so you know exactly what you're paying for.
Crawl Space Clearance
Code says wood joists closer than 18 inches to exposed ground, or girders closer than 12 inches, have to be treated or naturally durable wood. We check clearance while we're under there, because low framing over damp soil is the framing that rots first.
Why We Do Pier and Beam Repair the Slow Way
You can level a pier and beam house fast with a bottle jack and a bundle of shims. It'll also be back out of level within a year. We'd rather spend the extra day replacing the piers that are failing than shim on top of them.
Every pier and beam job starts with the same elevation survey we run on slabs, 40 to 80 readings, so we know which girders are low and by how much. If the perimeter beam needs piering, an independent engineer licensed in Texas reviews it, and we pull the city permit. Carrollton requires one for every foundation repair.
New pier pads carry our lifetime transferable warranty. Shim adjustments are covered for 24 months, because the clay under a freshly leveled house keeps moving for a season or two.
Our Pier and Beam Repair Process
Survey above and below
We shoot the floor from inside, then crawl the space to check every pier, shim, girder and sill.
Written plan and engineer
You get a plan within 24 hours. If the perimeter beam needs piering, an independent engineer reviews it and we file the permit.
Replace and repair
The crew sets new concrete pier pads, sisters damaged framing and presses pilings under the perimeter beam where needed.
Re-shim and level
We jack the girders in small steps and set steel shims, checking the manometer and the doors as we go.
Final survey and paperwork
We include a closing elevation survey in your warranty file. We also return once during the first 24 months if your shims need adjusting.
Pier and Beam Foundation Repair Questions
How long does a pier and beam re-level last?
A re-level stays solid for years with steel shims and sound piers. We cover shim adjustments for 24 months because the clay still moves. If a cedar stump is soft, we replace it. Shimming rotten wood isn't a permanent fix.
Do you have to tear up my floors?
We do all pier and beam repairs from the crawl space. We only open a floor if a section of the subfloor or a joist is rotted through. We'll show you the damage during the inspection before we put it on a quote.
What does pier and beam foundation repair cost?
A full re-level and re-shim costs $1,800 to $4,800. New interior pier pads cost $375 to $600 each. You can also get sill or girder sistering for $40 to $75 per linear foot. Whole-house leveling with pier replacement runs $3,500 to $9,500.
My crawl space access is tiny. Can you still work in it?
Usually. Our crews work in tight crawl spaces all the time. If the clearance is too low, we'll cut a new access point or dig a work path and then close it back up.
Is a permit required for pier and beam repair?
In Carrollton, every foundation repair needs a permit, with a plan designed by a professional engineer. We pull it for you and show the fee at the city's cost. Anywhere else, we pull the permit wherever the city requires one.
Schedule a Pier and Beam Inspection in Carrollton
Call (469) 896-0932 or send the form. We'll check the floor from above and the piers from below, then email you a written repair plan within 24 hours.